Take Me Back To Home PageGo To The Technical Data PageGo To The Masking Guide For Temporary Solder MasksGot To The Frequently Asked QuestionsE-mail Us At Contronic Devices Inc.Go To The Products PageGo To The Material Safety Data Sheet Page

Contronic Devices Inc.

Products:

Category:

Part Numbers:

Description:

Application:

Removal:

Shelf Life:

Storage:

Other Products:

KTM SOLDER MASK  DOTS

KAPTON SOLDER MASK DOTS

" -   3025

3/8" -  3038

" - 3050

" - 3075

1" - 3100

KTM Solder Mask Dots are designed to protect through holes on the circuit board during the wave solder operation. KTM Solder Mask Dots are made of a polyamide film with a silicone adhesive. It is chemical and heat resistant to withstand short exposures to 525F (274C).

KTM Solder Mask Dots apply directly from the roll to the surface to be masked.  The applied surface should be free of dirt, oil, and any other parting agents.

KTM Solder Mask Dots simply peel off after use.

KTM Solder Mask Dots will store up to 2 years from date of manufacturing.

KTM Solder Mask Dots should be stored at room temperature (72F, 22C) in an unopened container.

Other specialized masking materials are available upon request.

[Welcome] [Tech Data] [Guide] [FAQ'S] [Products] [Contact Us] [MSDS]

This Website was designed and is maintained by GLENARDS WEBDESIGN

Questions, Comments or To Place An Order?

E-mail: Contronic Devices Inc.

Phone: (714)897-2266

Fax: (714)897-6262

Copyright © 2003 by Contronic Devices Inc. All rights reserved.