Take Me Back To Home PageGo To The Technical Data PageGo To The Masking Guide For Temporary Solder MasksGot To The Frequently Asked QuestionsE-mail Us At Contronic Devices Inc.Go To The Products PageGo To The Material Safety Data Sheet Page

Contronic Devices Inc.

Products:

Category:

Part Number:

Description:

Application:

Removal:

Shelf Life:

Storage:

Other Products:

PC FLEX-MASK P-2

CONFORMAL COATING MASK AND TEMPORARY SOLDER MASK

Gallon 2450

16 oz. Bottle - 2440

8 oz. Bottle 2430

PC Flex-Mask P-2 is a pink single-component natural latex rubber that cures at room temperature and is ideally suited for conformal coasting mask or large hole solder mask. This material is formulated to withstand temperatures up to 268C/515F during the normal soldering operation (not to exceed 5 seconds). Once used to mask, this material is manually peeled off and discarded.

PC Flex-Mask P-2 is applied using the plastic squeeze bottle supplied by cutting the nozzle to the desired bead size and applying to selected areas.  It will adhere to circuit boards that are clean and dry prior to application. PC Flex-Mask P-2 cures in approximately 40 minutes at room temperature (22C/72F) and relative humidity of less than 40%. The cure time could vary according to the mask thickness and relative humidity conditions.  Optimum thickness would range between 10-30 mils.

PC Flex-Mask P-2 removes easily by hand or tweezers. Simply lift one corner and pull.  A slight lifting action will remove PC Flex-Mask P-2 all in one piece leaving no residue.  For best results, PC Flex-Mask P-2 should be removed as soon as possible after the cleaning operation.

PC Flex-Mask P-2 has a shelf life of 6 months from date of manufacture. Each container is stamped to show the batch number, date of manufacture and expiration date.

PC Flex-Mask P-2 must be protected from freezing.  Store at room temperature in an unopened container.

PC Flex-Mask P-2  is available in different viscosities and colors. Please refer to Technical Data Bulletin #TD9000 The Complete Masking Selection Guide.

[Welcome] [Tech Data] [Guide] [FAQ'S] [Products] [Contact Us] [MSDS]

This Website was designed and is maintained by GLENARDS WEBDESIGN

Questions, Comments or To Place An Order?

E-mail: Contronic Devices Inc.

Phone: (714)897-2266

Fax: (714)897-6262

Copyright © 2003 by Contronic Devices Inc. All rights reserved.