Take Me Back To Home PageGo To The Technical Data PageGo To The Masking Guide For Temporary Solder MasksGot To The Frequently Asked QuestionsE-mail Us At Contronic Devices Inc.Go To The Products PageGo To The Material Safety Data Sheet Page

Contronic Devices Inc.

Products:

Category:

Part Numbers:

Description:

Application:

Removal:

Shelf Life:

Storage:

Other Products:

PC FLEX-MASK P-1   - REGULAR VISCOSITY

TEMPORARY SOLDER MASK

Gallon 2050

16 oz. Bottle 2040

8 oz. Bottle - 2030

PC Flex Mask P-1 Regular Viscosity is a pink single-component natural latex rubber that  cures at room temperature.  This material is formulated to resist the adhesion of solder to specified areas of the circuit board during the soldering operation.  It will withstand temperatures up to 268C/515F during the normal soldering operation (not to exceed 5 seconds).  Once this material is used to mask the circuit board from solder, it is then manually peeled off and discarded. Other applications include sealing molds, masking conformal coating areas and holding components during wave solder.

PC Flex Mask P-1 Regular Viscosity is applied using the plastic squeeze bottle supplied by cutting the nozzle to the desired bead size and applying to selected areas.  It will adhere to circuit boards that are clean and dry prior to application.  PC Flex Mask P-1 Regular Viscosity cures in approximately 40 minutes at room temperature (22C/72F) and relative humidity of less than 40%. The cure time could vary according to the mask thickness and relative humidity conditions.  Optimum thickness would range between 10-30 mils.

PC Flex Mask P-1 Regular Viscosity removes easily by hand or tweezers.  Simply lift on corner and pull.  A slight lifting action will remove PC Flex Mask all in one piece, leaving no residue. For best results, PC Flex Mask P-1 Regular Viscosity should be removed as soon as possible after the cleaning operation.

PC Flex Mask P-1 Regular Viscosity has a shelf life of 6 months from date of manufacture.  Each container is stamped to show the batch number, date of manufacture and expiration date.

PC Flex Mask P-1 Regular Viscosity must be protected from freezing. Store at room temperature in an unopened container.

PC Flex Mask P-1 Regular Viscosity is available in different viscosities and colors. Please refer to Technical Data Bulletin #TD9000 The Complete Masking Selection Guide.

[Welcome] [Tech Data] [Guide] [FAQ'S] [Products] [Contact Us] [MSDS]

This Website was designed and is maintained by GLENARDS WEBDESIGN

Questions, Comments or To Place An Order?

E-mail: Contronic Devices Inc.

Phone: (714)897-2266

Fax: (714)897-6262

Copyright © 2003 by Contronic Devices Inc. All rights reserved.